Daktronics

Diagnostic Event: Photocell Failure

Potential Symptoms

  • Display may appear dim via webcam if viewed during daytime hours (dimming issue may not be noticeable if viewed at night).

Diagnostic Event(s)

  • Photocell Failure alert on either the VLink or Valo.
  • Light sensor value shows Not Reporting.

Environment

  • Product: System Health, IDM
  • Component: outdoor displays
  • Control System: Venus Control Suite

Cause

The brightness of an outdoor display is often controlled by a photocell which automatically adjusts the display's dimming level in response to changes in ambient light. If a photocell is not connected, the controller will set the display to the minimum dimming level until the dimming mode is changed to manual, or the photocell is repaired.

  • Failed photocell.
  • Failed controller.
  • Broken connection between photocell and VLink.

Remote Troubleshooting Steps

  • Contact Daktronics for assistance.

Onsite Troubleshooting Steps

  1. Check the display's webcam to evaluate the readability of the display.

  2. Using the Remote Display Configuration utility, verify that the settings for latitude and longitude are correct (Configuration tab > GPS > GPS Configuration) and set the dimming mode to GPS dimming (Display Control tab > Dimming mode).

  3. If GPS dimming is not supported, set the Dimming mode to manual and set a dimming level appropriate for the time of day (Display Control tab > Dimming mode).
    Note: If using the manual dimming mode and service is not expected before the dimming level needs to be adjusted (sunrise or sunset at the display), set a reminder to adjust the manual dimming level as necessary.

Related Resources

Diagnostic Event: Photocell Failure, wires connected incorrectly at VLink or I/O card

Diagnostic Alert: Display is dim, "Photocell Failure" event in Diagnostics, Failed photocell

Diagnostic Event: Controller too Dim

 

KB ID: DD1980835

DISCLAIMER: Use of this content may void the equipment warranty, please read the disclaimer prior to performing any service of the equipment.

DAKTRONICS DOES NOT PROMISE THAT THE CONTENT PROVIDED HEREIN IS ERROR-FREE OR THAT ANY DEFECTS WILL BE CORRECTED, OR THAT YOUR USE OF THE CONTENT WILL PROVIDE SPECIFIC RESULTS. THE CONTENT IS DELIVERED ON AN "AS-IS" AND "AS-AVAILABLE" BASIS. ALL INFORMATION PROVIDED IN THIS ARTICLE IS SUBJECT TO CHANGE WITHOUT NOTICE. DAKTRONICS DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ANY WARRANTIES OF ACCURACY, NON-INFRINGEMENT, MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. DAKTRONICS DISCLAIMS ANY AND ALL LIABILITY FOR THE ACTS, OMISSIONS AND CONDUCT OF YOU OR ANY THIRD PARTIES IN CONNECTION WITH OR RELATED TO YOUR USE OF THE CONTENT. ADJUSTMENT, REPAIR, OR SERVICE OF THE EQUIPMENT BY ANYONE OTHER THAN DAKTRONICS OR ITS AUTHORIZED REPAIR AGENTS MAY VOID THE EQUIPMENT WARRANTY. YOU ASSUME TOTAL RESPONSIBILITY FOR YOUR USE OF THE CONTENT AND ANY LINKED CONTENT. YOUR SOLE REMEDY AGAINST DAKTRONICS FOR DISSATISFACTION WITH THE CONTENT IS TO STOP USING THE CONTENT. THIS LIMITATION OF RELIEF IS A PART OF THE BARGAIN BETWEEN THE PARTIES.

The above disclaimer applies to any property damage, equipment failure, liability, infringement, or personal injury claim arising out of or in any way related to your use or application of the content, whether such claim is for breach of contract, tort, negligence or any other cause of action.